Kukko 120-ST Sales display "Economy"

Description

• The sales and workshop stands enable 2-jaw pullers to be stored and presented safely.
• Standard pulling hook.
• The end stop protects the hook from slipping off the cross-beam.
• Two-arm design for space-saving operation.
• Pulling hooks with infinitely variable adjustment on the cross-beam.
• If there is adequate free space around the part to be removed, we recommend using a 3-jaw puller.
• Mechanical pressure screw.
• Exchangeable spindle top.
• Milled thread treated with special coating.

Use

• For removing bearings, gears, discs, etc.

Advantage

• Quick change or turning of the pulling jaws by depressing the end stop.
• Turning the pulling hooks enables them to be used both internally and externally.
• Suitable for pulling asymmetric workpieces.
• Spindle head band prevents the wrench from slipping off.
• Almost all components available as replacement parts, time-saving order process thanks to numbering system.

How it works

• The part due to be removed (e.g. a gear, pulley or ball bearing) is gripped from the outside. Tightening of the pressure screw and the resulting pressure removes the part from the shaft.
• The puller must be positioned centrally for centre shafts. If the shaft is not sitting centrally, the parts can be removed asymmetrically with pullers with parallel pulling hooks.

Safety information

• The pulling hooks´ sliding parts must always sit stably and fully on the cross-beam.
• If several parts have to be removed, always follow a step-by-step process. Do not remove several parts at the same time.
• The pulling hooks´ support surfaces must always be straight and sit fully beneath the part to be removed.
• Do not use any electrical or pneumatic servo screwdrivers or hammer drills.
• Protective blanket required.
• Protective goggles required.

Content