MIKE SANDERS Spraygun with pressurised container   Features: A problem that occurs at each cavity sealing is that you can not see, whether the preservative reaches all places. More important is therefore a powerful gun, that disperses the material through a 360° nozzle. The more thicker the material, the more difficult gets its distribution. To use cavity wax, ultimately remains only the pressure cup method. In this case, the pressure cup projects into a tube which is connected directly to the probe. The beaker is set through a bore from the top pressure, that the applied pressure is also applied to the nozzle front. Only the pressure cup method is possible a fine spray nozzle at the front of the use of long, thin probes. This gun can also be used for processing by Mike Sanders Anti-corrosion grease. Supplied a hook probe with handle and a 360 ° probe for cavity protection are included. The probes have 6 mm outer diameter and a length of 1100 mm. The hook probe can also be used for "targeted" processing of underbody protection.The beaker is set through a bore from the top pressure, ie that the applied pressure is also applied to the nozzle front. Only the pressure cup method is possible a fine spray nozzle at the front of the use of long, thin probes. This gun can also be used for processing by Mike Sanders Anti-corrosion grease. Supplied with a hook probe with handle and a 360 ° probe for cavity protection are included. The probes have 6 mm outer diameter and a length of 1100 mm. The hook probe can also be used for "targeted" Processing of underbody protection.   Directions for Use To improve the penetration into the seams and corners, heating in a spray booth ore with a hot air pistol is possible, although when applied, in the summer months this is not necessary. As a precautionary measure it is recommended to cover the vehicles with a plastic foil and to place newspapers underneath the water draining holes in the bodywork. Grease that drops out of the vehicle during treatment can be re-heated and used again. This product is especially effective when used under screws, chrome strips and light fittings. Nuts and bolts that have been treated will undo easily even after years of neglect. An examination of the vehicle in respect of corrosion and if necessary an additional treatment is recommended every 2-4 years.   Scope of Delivery Supplied we deliver a hook probe with handle and a 360 ° probe for cavity protection The probes have 6 mm outer diameter and a length of 1100 mm. The hook probe can also be used for "targeted" processing of underbody protection.   Technical Features: Max. Pressure: 8 bar Working Pressure: 2-6 bar Filling quantity: 0,9 l